AVERMEDIA, INC.

AVER FADER

Category                     Video/ Fader/ Overlay card
Video Types Supported        XVGA
Video Processor              N/A
Highest Resolution Supported 1024 x 768
Data Bus Type                8-bit ISA
Memory Type                  N/A
Maximum Onboard Memory       N/A

[Image]

                                CONNECTIONS

      Purpose          Location            Purpose            Location

  15-pin analog           CN1        Phone jack (fader           J1
  video port - in                    box)

  15-pin analog           CN2        VGA Overlay                U45
  video port - out                   connector

      VGA SYNC SIGNAL CONFIGURATION

       Setting               JP1

      Composite       Pins 1 & 2 closed

     Horizontal       Pins 2 & 3 closed

                        BLUE VIDEO SIGNAL SELECTION

                Signal                                 JP2

  »                  V                          Pins 1 & 2 closed

                    Blue                        Pins 2 & 3 closed

                       GREEN VIDEO SIGNAL SELECTION

                Signal                                 JP3

  »                  U                          Pins 2 & 3 closed

                   Green                        Pins 1 & 2 closed

                        RED VIDEO SIGNAL SELECTION

                Signal                                 JP4

  »                  Y                          Pins 1 & 2 closed

                    Red                         Pins 2 & 3 closed

                     COLOR KEY SIGNAL TIMING SELECTION

                Setting                                JP5

  »               8ns delay                     Pins 9 & 10 closed

                 16ns delay                     Pins 7 & 8 closed

                 24ns delay                     Pins 5 & 6 closed

                 32ns delay                     Pins 3 & 4 closed

                 40ns delay                     Pins 1 & 2 closed

  Note: JP5 must be in the default setting if you do not use the color
  key signal output.

         COLOR KEY SIGNAL OUTPUT/VERTICAL SYNC/SCART RGB SELECTION

                 Setting                                JP6

  »     RS-170 Color Key Signal Output           Pins 1 & 2 closed

         TLL Color Key Signal Output             Pins 3 & 4 closed

               SCART RGB Select                  Pins 5 & 6 closed

                Vertical Sync                    Pins 7 & 8 closed

   INPUT VIDEO IMPEDANCE TERMINATION CONFIGURATION (Y/RED VIDEO SIGNAL)

                 Setting                                SW1/1

  »              75ohm enabled                           On

                75ohm disabled                           Off

  INPUT VIDEO IMPEDANCE TERMINATION CONFIGURATION (U/GREEN VIDEO SIGNAL)

                 Setting                                SW1/2

  »              75ohm enabled                           On

                75ohm disabled                           Off

   INPUT VIDEO IMPEDANCE TERMINATION CONFIGURATION (V/BLUE VIDEO SIGNAL)

                 Setting                                SW1/3

  »              75ohm enabled                           On

                75ohm disabled                           Off

                        BASE I/O ADDRESS SELECTION

     Address          SW2/1         SW2/2         SW2/3          SW2/4

  »      29Ah          Off            On            On            Off

         20Ah           On            On            On            On

         21Ah          Off            On            On            On

         22Ah           On           Off            On            On

         23Ah          Off           Off            On            On

         24Ah           On            On           Off            On

         25Ah          Off            On           Off            On

         26Ah           On           Off           Off            On

         27Ah          Off           Off           Off            On

         28Ah           On            On            On            Off

         2AAh           On           Off            On            Off

         2BAh          Off           Off            On            Off

         2CAh           On            On           Off            Off

         2DAh          Off           Off           Off            On

         2EAh           On           Off           Off            Off

         2FAh          Off           Off           Off            Off

  FACTORY CONFIGURED - DO NOT ALTER

      Switch            Position

       SW1/4               N/A